Hello Karl, Let's see if we can figure this out, we usually do. Remove the snubber attached to the relay that switches 12v power ON/OFF to serve the Bylund shield. (Arduino has a separate power circuit with a step-down that reduces 12v to 5v.) Could you please clarify how you are powering the device...

there is nothing showing in the sale store. i would like to purchase a lambda sensor board for an arduino. also you should look into making out for a "pi" computer. they are slowly being used more than the arduino. thanks tim Hello Tim, I have not found any issues with our store neither t...

Mallang2 wrote: ↑

21 Aug 2024 13:51

Hello, I bought a lambda Shield kit a few hours ago in South Korea. But I just received a cancellation text message. Can you tell me the reason for the cancellation?

Hello, answered by email.

Christian, O2 system in the works is a single wideband sensor, Arduino, Shield, with a single OLED .96” display. Is in ‘85 911 3.2 with SSI exhaust that has a single bung on the 1-2-3 side. Am planning to add an O2 sensor to the 4-5-6 side. As the setup is, a single OLED display works nicely (takin...

Hi Christian... looking at your YouTube vids, the shield you are working with has headers. Was just setting up to bench test and my shield has no headers. Pardon me as I have only a small degree of Arduino experience so until I get the system working... I may stumble around and need more assistance...

Hi Karl, please check your email spam folder. You will find both your order confirmation and tracking number. I have also responded to your email.

Thank you.

Hi Christian, yes I'm using the Lambda-shield 2, I think I misunderstood your YT-Video that OLED- is implemented, but it's only implementd for the Lambda shield 1-code. Correct? best regsrad steffen Hi Steffen, The video is based on the original Lambda Shield. Functionality is the same but there is...

Hi, I'm using the Lambda Shield with an Arduino uno wifi and an IPhone since two years. Now I like to use the OLED display SSD1306. The display works with the test-code "Hello World", but with the sketch for the Shield only the "Bylund-logo" appears on the display and nothing fu...

Hello, how can I connect a module to a 3.3-volt board like Arduino Due or ESP boards, and do I need a logic level shifter for SPI or not? Also what steps should I take for voltage levels UR and UA? Regards The Bosch CJ125 used on the Lambda Shields have 5V interfaces, why go through all that troubl...

Hello, i want to ask if anyone know how can i read the temperature before satrt heating the sensor. I want to detect from temperature that the engine is starting so after that start heating the sensor. With this i think i can protect the sensors for failure Thank you Hello, there is actually a pre-...