Search found 5 matches
- 21 Feb 2019 01:23
- Forum: Lambda Shield for Arduino
- Topic: Open Air readings
- Replies: 14
- Views: 47132
Re: Open Air readings
Hi I'm new here. I've made my own shield based on bylund information. It works but have some question- in open air a have a 20% content of oxygen. Most of resistors from schematic was 0.1% of precysion (not sure how to explain this value. I hope U anderstand). Is this normal? I have bosch sensor bu...
- 12 Feb 2019 16:05
- Forum: Lambda Shield for Arduino
- Topic: Open Air readings
- Replies: 14
- Views: 47132
Re: Open Air readings
Hey blacksheepinc I have a similar problem my heater Ur value goes under 100 and the shield reads 21%o2 then if fluctuates to 174 ur and the readings go to 12%o2 and just bounce between to two values I am trying to figure out what's wrong if you make headway let me know. With the sensor disconnecte...
- 12 Feb 2019 10:47
- Forum: Lambda Shield for Arduino
- Topic: Open Air readings
- Replies: 14
- Views: 47132
Re: Open Air readings
Hello Christian, Actually I have something similar problem. After heating phase(sensor gets hot also), it stops with error message 0xE8FF. Also, if I modify the code it turned out, the the calibrations values are "normal" Ur=173, Ua=303, however when it exists from calibration mode, Ur is...
- 11 Feb 2019 03:03
- Forum: ADAS - Dynamometer
- Topic: What does the ADAS DYNAMOMETER do exactly
- Replies: 0
- Views: 109222
What does the ADAS DYNAMOMETER do exactly
What does the ADAS DYNAMOMETER do ?
- 11 Feb 2019 02:47
- Forum: Lambda Shield for Arduino
- Topic: Win GUI not working with latest Arduino code
- Replies: 3
- Views: 8146
Win GUI not working with latest Arduino code
Win app not working with latest Arduino code with look up table