Making the Shield
Posted: 14 Feb 2024 22:33
Hello, I assembled a NOx shield exactly according to the electronic diagram in the technical manual, but it does not communicate with the probe. I have a shield and a probe purchased from you.
When I connect the probe to the Bylund shield it works perfectly, but when I connect it to my shield it does not communicate with the probe ("Waiting for sensor to respond...").
Is there any difference between the CAN network chip?
When I connect the probe to the Bylund shield it works perfectly, but when I connect it to my shield it does not communicate with the probe ("Waiting for sensor to respond...").
Is there any difference between the CAN network chip?