Analog Input A3
Posted: 06 Jul 2021 16:51
Hello,
I use the Lambda Shield 2 in the Racingteam at our university to read and modify the lambda value.
My issue is, that I want to use the analog input pin A3 to read the throttle value but on this pin are 3.3V connected as seen in the schematics.
I can't use A4-5 because a DAC is connected on these pins.
So why I need to measure 3.3V or can I disconnect them?
Because I did not find anything in the code, that need these 3.3V.
I use the Arduino Uno and did not want to upgrade.
Sorry if my english is not perfect. :)
Best regards
Robin
I use the Lambda Shield 2 in the Racingteam at our university to read and modify the lambda value.
My issue is, that I want to use the analog input pin A3 to read the throttle value but on this pin are 3.3V connected as seen in the schematics.
I can't use A4-5 because a DAC is connected on these pins.
So why I need to measure 3.3V or can I disconnect them?
Because I did not find anything in the code, that need these 3.3V.
I use the Arduino Uno and did not want to upgrade.
Sorry if my english is not perfect. :)
Best regards
Robin