Page 1 of 1
0-5v output
Posted: 23 Apr 2018 21:48
by Stevo
Hello,
Is there a analog output (0 - 5v) on this shield? I want to connect it to our dyno software as it can read analog voltates between 0 and 5 volts. Please tell me how i can do this.
Thank you!
Re: 0-5v output
Posted: 23 Apr 2018 23:24
by Christian_Bylund
Stevo wrote:Is there a analog output (0 - 5v) on this shield? I want to connect it to our dyno software as it can read analog voltates between 0 and 5 volts.
Hi again Stevo, as a matter of fact the Bosch CJ125 itself has a 0-5V output, more or less. You can access it from the Analog 0 pin of the Arduino / Shield. In the technical manual and schematics you are looking for what is called CJ125_UA. With the voltage you can convert this value to a lambda or AFR value as described in the technical manual.
How the voltages correspond to lambda values can also be seen in the
Bosch data sheet of the sensor. Look in the column v=17 as this is the default amplification for the shield.
Be aware that this is not a professional dyno tool, it most certainly can be used as one. Just make sure you are not picking up interferences or run in to vibration issues with connections.
Good luck!