Hello, I'm testing with the shield lambda ... is with 12v power on and jumper x7 connected,
but the power and heater LEDs do not light, what can it be ?
Lambda Shield on Arduino Mega
Lambda Shield on Arduino Mega
Last edited by Christian_Bylund on 28 Oct 2019 18:16, edited 1 time in total.
Reason: Changed title for future references.
Reason: Changed title for future references.
- Christian_Bylund
- Posts: 270
- Joined: 07 Mar 2015 18:09
Re: LEDs do not light
Hello,
Could you please take a picture of the set up. Refer to which software you are using. And what sensor you are using.
What is the serial output?
I think we can sort this out.
Thank you.
Could you please take a picture of the set up. Refer to which software you are using. And what sensor you are using.
What is the serial output?
I think we can sort this out.
Thank you.
Best Regards,
Christian Bylund
Bylund Automotive AB
Christian Bylund
Bylund Automotive AB
Re: LEDs do not light
Hi Christian, I was trying to plug in a Mega Arduino and it didn't work, after I plugged in Uno it worked ...
Thanks a lot for the help...
Thanks a lot for the help...
- Christian_Bylund
- Posts: 270
- Joined: 07 Mar 2015 18:09
Re: LEDs do not light
Good news, to use the Lambda Shield with Arduino Mega you need to reroute the SPI pins.
See example on our Instagram account.
https://www.instagram.com/p/BvZv4_GAOl2
Thank you.
See example on our Instagram account.
https://www.instagram.com/p/BvZv4_GAOl2
Thank you.
Best Regards,
Christian Bylund
Bylund Automotive AB
Christian Bylund
Bylund Automotive AB