Hi knockretard, Just wanted to also raise the topic of mounting torque. I assume you are aware of this anyway, but i wanted to add this for other readers of your post. Make sure that both sensors are torqued to the recommended spec of 20 + or - 5 Nm. Also try to use bolts or studs made from the same...

Hi Christian,
thank you very much for your reply.
I shall recheck and run the sketch.
Thanks again for your help.
Kind Regards
Dave.

Hi Christian, how are you, I need to know a couple of things to jolt the old memory. I still own a very early Version 1 Lambda Shield. I have a new Laptop and i used the UNO i used to have my LAMBDA Shield on for another project. So i no longer have the original ino. files for the Board or the file ...

Hi DonP, Not intending to highjack this thread, but when reading through the task list it came to my mind that maybe some basic software interface to adjust these values would very much lower the entry level: - Knock sensor measurement timing. - Knock sensor amplification and gain. - Knock sensor f...

Hi Wolf,
that's a very nice little kit you have assembled there, very well done, looks great.
Regards
Dave.

Hi Christian,
i am still saving my hard-earned coins to buy a couple of these for testing.
Well i don't really need to test i just want to use as it is a cheaper alternative to most options that are out there.
Regards
Davde.

Hi Wolf,
nice job.
Looks very neat and effective.
Regards
Dave.

Great job Christian,
thanks for the support you are giving us with your great products.
Regards
Dave.