How to change firmware settings?

Support forum for the Knock Shield designed to connect knock sensors to Arduino projects.
Post Reply
Blitzuino
Posts: 2
Joined: 20 Oct 2022 02:04

How to change firmware settings?

Post by Blitzuino » 20 Oct 2022 13:31

Hello, I am French and I work on Speeduino. I'm used to using Arduino, but I'm not used to dealing with firmwares. I would like to add knock detection to my edits.

I looked at your Super Knock Shield firmware in Arduino IDE, and from what I understand I need to change some values ​​for it to work properly with the motor.

how should I do it ? I just have to upload the firmware with the correct values? is there another trick?

I have everything I need, a clean RPM signal to hook up to it, I could use the alert LED channel to activate a correction ignition table, maybe even with a 0-5v output I I could pass it off as a flexfuel sensor, which would make it possible to use the flexfuel menu to apply a precise correction according to the % of irregularities. it is an idea.

I looked at your other work, it's really handy. I have a question: is it possible to upload the Knock Shield and the wideband on the same Arduino? I'm thinking of a mega 2560 pro. taking care that the routes are not common and change them if necessary.

thanks for reading, sorry for my english!

Post Reply