Page 1 of 1

Lambda Shield stuck heating

Posted: 11 Jul 2018 20:47
by Terrigeno
Hello,

we had a problem with our lamba shield and the capacitor (C5) broke / snapped from the board during instalation.
We tried soldering it again and we made a test. The shield turns on but the heating led starts blinking and doesn't stop.
I tried opening the software but it just keeps "heating" but is doesn't ever heat.

Any ideas what may be causing this problem? What can we do?

thanks in advance,

Terrigeno Team

Re: Lambda Shield not working!!!

Posted: 12 Jul 2018 10:40
by Christian_Bylund
Hi!

Unfortunate with the C5 capacitor. Assuming that you have soldered it in place and it is working. It sounds like you are using a non original sensor. Please confirm you are using an original Bosch LSU 4.9 wideband sensor? If it is an original Bosch sensor, please let me know the pnc of it.

Thank you.